Hoppa till innehåll
Free shipping over 3000 kr excl. VAT! Volume discount: 5 pcs 2% · 10 pcs 3% · 25 pcs 5%
Volume discount: 5 pcs 2% · 10 pcs 3% · 25 pcs 5%How to see the solder joint and the scratch without holding a magnifier over the circuit boardThe cold room was too warm last night, but nobody can show for how longWhy Two Operators Get Different Readings in the Same Bore, and How to Eliminate the DifferenceThe scratch is visible to the eye but not in the report: how to measure directly on the microscope imageWhy a two-point measurement of a bore often shows the wrong diameter, and how a three-point micrometer solves itThree seconds instead of half a minute: how core temperature checks become a routine that actually gets doneA Hundred Bearing Seats per Shift: Read the Deviation Directly Instead of Calculating the DiameterThe hole measures correctly at the mouth but is tapered further in: how to find the fault without cutting up the partOne Second Is Enough to Tell Whether the Core Temperature PassesThree contact points give a bore measurement that doesn’t depend on who is holding the instrumentVolume discount: 5 pcs 2% · 10 pcs 3% · 25 pcs 5%How to see the solder joint and the scratch without holding a magnifier over the circuit boardThe cold room was too warm last night, but nobody can show for how longWhy Two Operators Get Different Readings in the Same Bore, and How to Eliminate the DifferenceThe scratch is visible to the eye but not in the report: how to measure directly on the microscope imageWhy a two-point measurement of a bore often shows the wrong diameter, and how a three-point micrometer solves itThree seconds instead of half a minute: how core temperature checks become a routine that actually gets doneA Hundred Bearing Seats per Shift: Read the Deviation Directly Instead of Calculating the DiameterThe hole measures correctly at the mouth but is tapered further in: how to find the fault without cutting up the partOne Second Is Enough to Tell Whether the Core Temperature PassesThree contact points give a bore measurement that doesn’t depend on who is holding the instrument
Item number 64-855613

Lever-type dial test indicator, dial diameter Ø46.5 mm, measuring range 0-0.5 mm

1.612 SEK

In stock

Lever-type dial test indicator
Dial diameter Ø46.5 mm
Measuring range 0-0.5 mm

Request a quote 64-855613

Volume discount: 5 pcs: 2% · 10 pcs: 3% · 25 pcs: 5%

Category:

Description

A lever-type dial test indicator is a measuring instrument with a pivoting lever, used to check small deviations and compare dimensions on a surface. It is typically used where a standard dial gauge cannot reach, for example when aligning workpieces on machines, checking flatness and runout, and measuring in confined spaces.

  • Dial diameter: Ø46.5 mm
  • Measuring range: 0-0.5 mm
Additional information
Weight 0,03 kg
Reviews (0)

There are no reviews yet.

Be the first to review

Your e-mail address is not published.

Your rating *